DD-WRT will take a minute to save changes and reboot. After that, your new extended WiFi should be up and running. Summary. To be sure that the setup is working properly, you can test it by running ping command on your PC once you connect on the repeater or straight from the DD-WRT command interface.

Universal Wireless Repeater - Uses a program/script called AutoAP to keep a connection to the nearest/best host AP. [ edit] Client / Client Bridge Connect two wired networks using a WiFi link (WIRELESS connection between two routers). The secondary router must have dd-wrt installed; the primary router does not need to have dd-wrt. There are more details on the DD-WRT wikibut the main idea is that you set the WAN to "Disabled", Disable DHCP, and plug the AP into your network using one of the LAN ports instead of the WAN port (or use the "Assign WAN Port to Switch" feature). The micro version of DD-WRT is the only version for Broadcom routers with 2MB flash. It is stripped-down with only basic features to fit in the limited flash space, and additional software packages are unlikely to fit. Despite these limitations, for existing owners, DD-WRT micro is likely to add additional functionality over OEM firmware. Jan 19, 2009 · Creating a Wireless Access Point using DD-WRT - Refresh 19 January 2009 on DD-WRT, How To, Linksys, Tomato, WRT150N, WRT54G. I found a setup that I like even better than my previous one. I have highlighted the main differences, in red, below. To set it up as repeater do the following: Do a 30 second reset; Under wireless->basic settings

Provided that the GUI implementation of PPTP doesnt redirect your gateway through the tunnel, and PPTP in your version of DD-WRT functions. Note: This procedure was tested on an ASUS RT-N16 running DD-WRT v24-sp2 (12/08/11) big (SVN revision 17990M NEWD-2 K2.6 Eko) I have not tested this with PPTP.

May 19, 2018 · With DD-WRT, we want to create a virtual access point (VAP) so that: The main APs (2.4 GHz and 5 GHz) are not routed through VPN. You get the IP address assigned by your ISP. The VAP runs on The number of AP's that AutoAP should keep track of at one time. The default is 10, so after trying to connect to 10 access points, AutoAP will take another full scan and get a fresh list of URLs. If you live in a Wi-Fi heavy area, and your router doesn't move much, you can safely increase this to 15 or so. The AP running dd-wrt has the CTS Protection mode is set to Auto by default and then you could adjust the RTS threshold value to something lower then 2346 (Which is the default fragmentation threshold value on dd-wrt) on the AP. 2.) The primary and secondary (DD-WRT Client Mode) routers must be on separate subnets, and NAT is used between them. Thus, when port forwarding is needed it must be configured at both routers - not just on the host router. A Client Mode router uses its own DHCP server for IP Address, Gateway, and DNS server to connected devices.

Jul 07, 2017 · Please check out the DD-WRT Wiki pages below for more information before performing a hard reset and make sure you follow their instructions because otherwise you might permanently damage and

Buy ASUS RT-N13U/B Wireless 3 in 1(Router, Repeater, AP) Router w/ USB can support 3G(AT&T,T-Mobile,Verizon) USB dongle WIFI sharing and All-in-One Printer Server(Open source DD-WRT Support) IEEE802.11n with fast shipping and top-rated customer service.